HESYS Settlement — explained walkthrough 3 minutes • Silent, with on-screen explanations • Trial 0.12 Edited actual application screens; fictional demonstration. 00:00 — Define the tunnel and ground Start with the alignment, tunnel diameter and depth. These place the excavation in the ground and on the map. This fictional example uses a 6 m tunnel, an axis depth of 25–30 m and an initial volume loss of 1%. Check the geometry, units and ground assumptions before calculating. 00:20 — Test a different assumption Volume loss is an input representing ground loss as a percentage of the excavated tunnel volume. Here it changes from 1% to 1.5%. Comparing assumptions helps you see how sensitive the estimated movement is to the selected loss. An entered loss percentage is an assumption, not a measured outcome. 00:40 — Calculate the mapped movement Select Run analysis after changing an input. The empirical model updates the ground-movement estimates for the selected settings. Contour lines join locations with the same calculated movement. Read the selected quantity, units and contour interval to understand the pattern around the alignment. Wait for Results current before reviewing the revised output. 01:00 — Read movement along a section A section turns the map into a graph of movement against distance along A to B. The solid line shows settlement, with positive values downward. The dashed line shows signed horizontal movement along the section. Read both the peak and how the values change with distance. These are ground movements; the graph does not calculate building damage. 01:20 — Take the results into your workflow Use the export options to carry the selected outputs into CAD, GIS, Google Earth or Excel. Choose a format for the task: spatial outputs for drawing and mapping, or numerical data for further review. Keep the analysis settings with the exported results so the assumptions remain traceable. Check coordinates, units and the selected scenario when using an export. 01:40 — Set up the separate FE model The 2D finite-element slice is a separate calculation through the ground and tunnel. Here we load the dry Mohr–Coulomb example. Review the soil stiffness, strength, unit weight and initial stress assumptions. Together with the tunnel, lining and release settings, these define the example being solved. The FE slice does not generate the empirical contours shown on the map. 02:00 — Inspect the calculation mesh The mesh divides the ground into small elements connected at nodes. The FE calculation estimates movement across this discretised slice. Inspect the tunnel opening, the nearby element sizes and the model boundaries. This example has 932 nodes and 1,712 elements; those counts describe the model, not its accuracy. Mesh and boundary sensitivity need review before relying on a result. 02:20 — Understand the movement field After running the FE analysis, choose the result stage and movement component. This screen shows vertical movement at the final release stage. Read the colour scale in millimetres: positive values are downward and negative values upward. The field shows movement within the ground, not just at its surface. A peak inside the ground is different from peak surface settlement. 02:40 — Review the surface response Use the FE curves to read settlement and horizontal movement across the slice at the selected depth. At ground level, this fictional example gives about 5.55 mm peak settlement. Review the curve shape, units and signs alongside the input assumptions, then export the figures or data for your assessment. This is an example result, not an acceptance limit or a validated design.